VSI

CEC purchased the Carra Cel VSI product line from its original product developer. The product has been successfully sold to the aggregate industry for about 15 years. We have many owners that run 2 to 4 machines.

The Carra Cel can run rock on rock or closed table and a breaker block Carra Cel. Changing from rock on rock to closed table breaker block takes about one hour.

The model 70 can have 100 to 300 hp motors. The model 90 runs dual motors 150 to 250 hp. The owners will tell you they have a throughput of 1.2 tons per horsepower.

Sand can be produced as well as cubical aggregate. Feed size of the model 70 is 2 1/2 inches. The model 90 accepts 5 inch infeed.

Model 70 Carra-Cel™ Vertical Shaft Impactor

CEC Carra-Cel Vertical Shaft Crusher is the industry’s most advanced crusher. The Model 70 can operate from 150 to 300 horsepower, depending on the job to be done. 1 to 1.5 tons per hour per horsepower thru-put. The top picture shows a six port closed table (top removed) that has a 14” feed tube. It…

Continue reading

View the Model 70 Carra-Cel™ Vertical Shaft Impactor

Model 70 Vertical Shaft Impactor

Standard 6 x 16 Three Deck Screen Optional 6 x 20 Three Deck Screen CEC tri-axle chassis, under screen conveyor and discharge chute. Closing conveyor and closing chute. The screen has hydraulic raise and lower, access ladder, walkways and railings.

View the Model 70 Vertical Shaft Impactor

Model 70 Skid Mounted Vertical Shaft Impactor

The model 70 & 90 Skid Mounted Carra-Cel Crusher has special features the inventor patented. You can run rock on rock crushing or closed table and breaker block ring. It is less expensive in cost per ton to run rock on rock but some rock does not fracture easily and requires the breaker block assembly.…

Continue reading

View the Model 70 Skid Mounted Vertical Shaft Impactor

Model 90 RR Carra-Cel® Vertical Shaft Impactor

The 90 RR VSI is built to accept 4½ inch infeed with occasional 5 inch rocks. The crusher has an 18” feed tube, 44” enclosed (5) port tables, rock on rock breaker cells and dual motor drives. Standard motors are dual 200’s with 250’s as an option and 300 maximum. It’s through put is approximately…

Continue reading

View the Model 90 RR Carra-Cel® Vertical Shaft Impactor

Model 90 Track Mobile Vertical Shaft Impactor

The track mobile VSI runs on electric power the same as the skid mounted or wheel mounted units. The power is from an onboard generator set. It runs the drive motor and conveyors plus providing power to the electric drive hydraulic track drive system. The electric starters are solid state frequency starters on the main…

Continue reading

View the Model 90 Track Mobile Vertical Shaft Impactor

Closed Circuit Vertical Shaft Impactor (VSI)

Standard 6×16 Three Deck Screen Optional 6×20 Three Deck Screen CEC tri-axle chassis, under screen conveyor and discharge chute. Closing conveyor and closing chute. The screen has hydraulic raise and lower, access ladder, walkways and railings.

View the Closed Circuit Vertical Shaft Impactor (VSI)

Breaker Block – Vertical Shaft Impactors

The breaker block assembly pictured is a model 70 size. Please note the long and short breaker blocks. Extend the long block for wear and bring the short one up to the center position. When you have advanced the long ones as far as they will move and worn them down, retract them and move…

Continue reading

View the Breaker Block – Vertical Shaft Impactors